MIL-M-38510-103 Microcircuits, Linear, Voltage Comparators, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, voltage comparators. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73

MIL-M-38510/103H

NOTES:

1. VIN = 10 µs pulse width at 50 kHz, tTLH and tTHL ≤ 10 ns, and ZO = 50 n.

2. Setup procedure:

a. With VIN = 0 V, step VREF from -3.0 mV to +3.0 mV in 0.1 mV steps for subgroup 7, -4.0 mV to +4.0 mV for subgroup 8, and stop when output switches from high to low.

b. Change VREF from the reference value obtained above by the required VOD (overdrive). c. Apply VIN and measure response time.

3. All resistor tolerances are ±1 percent and all capacitor tolerances are ±10 percent.

4. CL includes scope, probe, and jig capacitance.

5. TA = +25°C for subgroup 7. For subgroup 8, the tests shall be performed twice, at TA = +125°C and TA = -55°C.

6. In an environment with excessive noise, a 0.01 µF capacitor may be placed between balance and balance/strobe pins.

FIGURE 5. Response time test circuit and waveforms for collector output for device types 04 and 05.