MIL-M-38510-103 Microcircuits, Linear, Voltage Comparators, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, voltage comparators. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73

MIL-M-38510/103H

NOTES:

1. VIN = 100 ns pulse width, 100 kHz repetition rate, tr and tf ≤ 5 ns (see waveforms).

2. Setup procedure: With S1 open and VIN = 3 V (device type 02), and VIN = 0 V (device type 03) adjust R1 for

VOUT = 1.5 V. Apply VOD (see note 5) and close S1, then apply VIN. (R1 voltage divider may be replaced with a variable power supply.)

3. All resistor tolerances are ±1 percent and all capacitor tolerance are ±10 percent .

4. For device type 02, ground strobe on idle side. For device type 03, unused strobe is left open.

5. See waveform for VOD values.

6. When VOD = 12 V, overdrive applied to device under test (DUT) = 10 mV.

FIGURE 4. Strobe release time test circuit and waveforms for device types 02 and 03.