MIL-M-38510/5558
TA8LE I. Electrical performance characteristics - Continued.
5/ Capacitance is measured between the designated terminal and VSS at frequency of 1 MHz and a signal amplitude of 50 mV rms maximum.
6/ Measured at the test vector determined to be worse case. Includes current through input pull-ups.
Instantaneous surge currents on the order of 1 ampere can occur during output switching. Voltage supply should be adequately sized and decoupled to handle a large surge.
7/ The symbols used herein are defined by the following:
tPXXY = propagation delay tPWXY = pulse width
tOOXXY = output to output relationship
tOIXXY = output to input relationship in accordance with MIL-STD-1553.
tSXXY = setup condition
tHXXY = hold condition
8/ tPHL5 and tPLH8 are guaranteed, but not tested. tPLH5 and tPHL8 are tested and are the worst case transitions.
9/ Supplied as a design limit, but not guaranteed or tested.
10/ tSHL9 is interpreted as follows: In order for MEMCK to be ignored during a DMARQ cycle, CS must be asserted no later than 13 ns before MEMCK falls.
11/ tHHL10 is interpreted as follows: In order for MEMCK to be recognized after a CS cycle, 10 ns must pass after CS is negated before MEMCK can fall.
12/ Allows a 20 ns data valid set before RCS and RRD/RWR go high.
13/ The sum of tSHL12 and tPW17 must not exceed 18.8 µs.
14/ Logical OR result of (CTRL + CS + RD/WR).
15/ Frequency ( f ) = 12.00 MHz and TC = +25°C.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business