MIL-M-38510-56 Microcircuits, Digital, Cmos, Counters/Dividers, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, CMOS, logic microcircuits. Two product assurance classes and a choice of case outlines, lead finishes, and radiation hardness assurance RHA are provided and are reflected in the complete Part or Identifying Number PIN. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535 see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58

MIL-M-38510/56G

NOTES:

1. Each output shall be measured as specified in table III.

2. For device types 01 through 05, the input-output voltage subscript numbers (VIH1, VOH1, etc.) are matched for each test. Each applicable load current is specified in table III.

3. See figure 2 for logic diagram and functional waveform.

4. To step counter through its sequence, momentarily place SW2 in position 2, then with SW1 increment counter to the to the correct output logic state for measurements. Set device type 02 DATA input high or

low to achieve correct input.

FIGURE 4. Test procedures and test circuits for output voltage and current measurements.