MIL-M-38510-121 Microcircuits, Linear Monolithic And Multichip, Silicon 12 Bit Digital-To-Analog ConvertersThis specification covers the detail requirements for monolithic silicon, bipolar, interface, memory core drivers. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52

MIL-M-38510/121A

Device types 02 and 03

Notes:

1. Unless otherwise stated, all capacitors are 47μF tantalum paralleled with 0.1 μF ceramic.

2. The volts rms meter bandwidth shall be greater than 100 kHz.

3. A1, A2, and A3 shall have a gain bandwidth product greater than 1 MHz and an input noise density less than

10 nV/ Hz .

4. With S-1 in position 2, the measured rms noise voltage shall be less than 1.0 mVrms. (NO for all bits off).

5. With S-1 in position 1, the measured rms noise voltage shall be

NO for DUT =

((NO)2for all bits on - (NO)2for all bits off - (NO)2 for Vref ) /100

6. VCC is +5 V for device 02 and +15 V for device 03. Pins 1 and 2 are not connected for device 03..

FIGURE 6. Output noise test circuit - Continued.