MIL-M-38510-121 Microcircuits, Linear Monolithic And Multichip, Silicon 12 Bit Digital-To-Analog ConvertersThis specification covers the detail requirements for monolithic silicon, bipolar, interface, memory core drivers. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52

MIL-M-38510/121A

0evice type 01

NOTES:

1. Unless otherwise defined, all capacitors are 47 μF tantalum paralleled with 0.1 μF ceramic.

2. Bandwidth of the oscilloscope shall be 50 MHz minimum; saturation of the preamp must be avoided.

Use a voltage comparator preamp.

3. Adjust the course and fine offset controls to position the waveform final value on the oscilloscope center horizontal graticule.

4. While operating switch S-1, adjust the oscilloscope vertical gain for ½ LSB per cm.

5. 01 = 02 = HP 5082 - 2835 or EQUIVALENT.

FIGURE 3. Test circuit for settling time.