MIL-M-38510-9 Microcircuits, Digital, Bipolar Ttl, Shift Registers, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, TTL, shift register microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.4.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78 - 79

TABLE III.  Group A inspection for device type 04 - Continued.

Terminal conditions (pins not designated may be H > 2.0 V or L < 0.8 V or open).

1/   C = after all other input conditions, but prior to measurement, apply momentary GND, then 4.5 V.

2/   For subgroups 7 and 8, A = VCC and B = GND.

3/  Output voltages shall be either:

(a)  H = 2.4 V minimum and L = 0.4 V maximum when using a high speed checker double comparator, or

(b)  H � 1.5 V and L < 1.5 V when using a high speed checker single comparator.

4/  The tests in subgroups 7 and 8 shall be performed in the sequence specified.

5/  Only a summary of attributes data is required.

6/  For device type 04, schematics incorporating a 4 kn base resistor in the clock input circuit, the minimum and maximum limits shall be -0.7 and -1.6 mA, respectively.

For schematics incorporating a 6 kn base resistor in the clock input circuit, the minimum and maximum limits shall be -0.4 and -1.3 mA, respectively.