MIL-M-38510-107 Microcircuits, Linear, Positive, Voltage Regulators, Monolithic SiliconThis specification covers the detail requirements for fixed output, monolithic silicon, positive voltage regulators. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78

MIL-M-38510/107D

Device table

RL shall be type RER 70 or equivalent.

* This value shall be used for case X. For case Y use RL = 14.3 ν.

NOTES:

1. ei = 1 Vrms at f = 2400 Hz (measured at the input terminals of device under test (DUT).

Ripple rejection (dB) = 20 log (eirms / eorms).

2. ci shall be minimum value to prevent oscillations of the device under test.

The maximum value of ci shall be 0.4 μF.

3. The meter for ei and eo shall have a minimum bandwidth from 10 Hz to 10 kHz and shall measure true rms voltages.

FIGURE 7. Ripple rejection test circuit for all device types.