MIL-M-38510-107 Microcircuits, Linear, Positive, Voltage Regulators, Monolithic SiliconThis specification covers the detail requirements for fixed output, monolithic silicon, positive voltage regulators. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78

MIL-M-38510/107D

NOTES:

1.    Dimensions are in inches.

2.    Metric equivalents are given for general information only.

3.    (Two leads) ϕb applies between L1 and .500 (12.70 mm) from the seating plane.

Diameter is uncontrolled in L1 and beyond .500 (12.70 mm) from the seating plane.

4.    Two leads.

5.    Two holes.

6.    Two holes located at true position within diameter .010 (0.25 mm).

7.    Leads having a maximum diameter .043 (1.09 mm) measured in gauging plane .054 (1.37 mm) + .001 (0.03 mm) -

.000 (0.00 mm) below the seating plane shall be located at true position within diameter .014 (0.36 mm).

8.    The mounting surface of the header shall be flat to convex within .003 (0.08 mm) inside a .930 (23.62 mm)

diameter circle on the center of the header and flat to convex within .006 (0.15 mm) overall.

FIGURE 2.   Case outline Y.

26