MIL-M-38510-107 Microcircuits, Linear, Positive, Voltage Regulators, Monolithic SiliconThis specification covers the detail requirements for fixed output, monolithic silicon, positive voltage regulators. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78

MIL-M-38510/107D

Dimensions
Symbol	Inches		Millimeters		Notes
Symbol	Min	Max	Min	Max	Notes
A	.165	.185	4.19	4.70
ϕb	.016	.019	0.41	0.48	3
ϕb1	.016	.021	0.41	0.53	3
ϕD	.335	.370	8.51	9.40
ϕD1	.305	.335	7.75	8.51
e	.200 T.P.		5.08 T.P		5
e1	.100 T.P.		2.54 T.P		5
F	---	.050	---	1.27
k	.028	.034	0.71	0.86
k1	.029	.045	0.74	1.14	4
k2	.009	.041	0.23	1.04
L	.500	---	12.70	---
L1	---	.050	---	1.27
L2	.250	---	6.35	---
α	45° T.P		45° T.P		5

NOTES:

1. Dimensions are in inches.

2. Metric equivalents are given for general information only and are based upon 1.00 inch = 25.4 mm.

3. (All leads) ϕb applies between L1 and L2. ϕb1 applies between L2 and .500 (12.70 mm) from the reference plane. Diameter is uncontrolled in L1 and beyond .500 (12.70 mm) from the reference plane.

4. Measured from the maximum diameter of the product.

5. Leads having a maximum diameter .019 (0.48 mm) measured in gauging plane .054 (1.37 mm) + .001 (0.03 mm) -

.000 (0.00 mm) below the base plane of the product shall be within .007 (0.18 mm) of their true position relative to a maximum width tab.

6. The product may be measured by direct methods or by gauge.

FIGURE 1. Case outline X.