MIL-M-38510-654 Microcircuits, Digital, High Speed, Cmos Latches, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, high speed CMOS, logic microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete Part or Identifying Number PIN. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535 see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64

MIL-M-38510/654A

NOTES:

1. Clock input pulse characteristics: tr = tf ≤ 6 ns.

2. Data, latch enable, and output enable input pulse characteristics: tr = tf ≤ 6 ns; tSETUP ≤ 30 ns;

tPULSE WIDTH ≤ 30 ns and tHOLD ≤ 15 ns.

3. CL = 50 pF and RL = 1000O.

4. Voltage measurements are to be made with respect to the network ground terminal.

5. For tPHZ and tPZH, a 1 kO resistor is connected between the output and GND terminal.

For tPZL and tPLZ, a 1 kO resistor is connected between the output and VCC terminal.

VS1 = VOL + 0.1 V (VOH - VOL). VS2 = VOH - 0.1 V (VOH - VOL).

6. The input signal for HCT device type 53 will be 0 - 3 V; however, the 50% VCC measure point is 1.3 V

for input and output signals. The 10% VCC and 90% VCC points are 0.3 V and 2.7 V, respectively.

FIGURE 3. Switching time test circuit and waveforms - Continued.