MIL-M-38510-653 Microcircuits, Digital, High Speed, Cmos Flip-Flops, Monolithic Silicon, Positive LogicThis specification covers the detail requirements for monolithic silicon, high speed CMOS, logic microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part or identifying number PIN. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535 see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70

MIL-M-38510/6538

NOTES:

1. OE1 and OE2 pulses are active low and one or both must be active to enable the outputs.

2. OE1 and OE2 input pulse characteristics are as follows: tr = tf ≤ 6 ns; tpOE1 = tpOE2 � 200 ns.

3. CL = 50 pF ±10 % (including test jig and probe capacitance).

4. OE1 or OE2 does not affect the sequential operation of the flip-flop.

5. For tPHZ and tPZH, a 1 kn resistor is connected between the output and the GND terminal. For tPZL and tPLZ, a 1 kn resistor is connected between the output and the VCC terminal. VS1 = VOL +0.1 V (VOH-VOL).

VS2 = VOH -0.1 V (VOH-VOL).

FIGURE 3. Three-state switching test circuit and waveforms (device type 06) - Continued.