MIL-M-38510-206 Microcircuit, Digital, 4096 Bit Schottky, Bipolar, Programmable Read-Only Memory PromThis specification covers the detail requirements for monolithic silicon, programmable read-only memory PROM microcircuits which employ thin film nichrome NiCr resistors, tungsten W or titanium tungsten TiW as the fusible link or programming element. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. A special test requirement is included in this specification to screen against devices which may contain excess moisture in the package materials or internal atmosphere see freeze-out test of 4.2d. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.4.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41

MIL-M-38510/206D

TABLE IVG. Programming characteristics for circuit G.

Parameter	Symbol	Conditions	Limits 1/			Unit
Parameter	Symbol	Conditions	Min	Rec	Max	Unit
VCC required during programming	VCCP		10.0	10.5	11.0	V
ICC during programming	ICCP	VCC = 11 V			750	mA
Required output voltage for programming	VOP		10.0	10.5	11.0	V
Output current while programming	IOP	VOUT = 11 V			20	mA
Rate of voltage change of VCC or output	IRR		1.0		10.0	V/µs
Programming pulse width (Enabled)	PWE		9	10	11	µs
Required VCC for verification	VCCV		3.8	4.0	4.2	V
Maximum duty cycle for VCC at VCCP	MDC			25	25	%
Address set-up time	T1		100			ns
VCCP set-up time	T2	2/	5			ns
VCCP hold time	T5		100			ns
VOP set-up time	T3		100			ns
VOP hold time	T4		100			ns

1/ TA = +25°C.

2/ VCCP set-up time may be greater than 0 if VCCP rises at the same rate or faster than VOP.

5. PACKAGING

5.1 Packaging requirements. For acquisition purposes, the packaging requirements shall be as specified in the contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-house contractor personnel, these personnel need to contact the responsible packaging activity to ascertain packaging requirements. Packaging requirements are maintained by the Inventory Control Point's packaging activity within the Military Service or Defense Agency, or within the military service's system command. Packaging data retrieval is available from the managing Military Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible packaging activity.

6. NOTES

(This section contains information of a general or explanatory nature which may be helpful, but is not mandatory.)

6.1 Intended use. Microcircuits conforming to this specification are intended for logistic support of existing equipment.