MIL-M-38510-117 Microcircuits, Linear, Adjustable, Positive, Voltage Regulators, Monolithic SiliconThis specification covers the detail requirements for three and four terminal monolithic silicon, adjustable, positive, voltage regulators. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.4.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60

MIL-M-38510/117C

NOTES:

1. Heavy current paths (I � 1.0 A) are indicated by bold lines.

2. Kelvin connections must be used for all output current and voltage measurements.

3. The operational amplifier stabilization networks may vary with test adapter construction.

Alternate drive circuits for the 2N6294 may be used to develop the proper load current and input voltage pulses.

4. The pulse generator for the pulse load circuit shall have the following characteristics. (See device table III.)

6. The oscilloscope shall have a bandwidth between 5 and 15 MHz.

7. Resistors R1 and R2 shall be type RER 70 or equivalent.

FIGURE 14. Load transient response test circuit - Continued.