MIL-M-38510-117 Microcircuits, Linear, Adjustable, Positive, Voltage Regulators, Monolithic SiliconThis specification covers the detail requirements for three and four terminal monolithic silicon, adjustable, positive, voltage regulators. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.4.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60

MIL-M-38510/117C

NOTES:

1.    Dimensions are in inches.

2.    Metric equivalents are given for general information only and are based upon 1.00 inch = 25.4 mm.

3.    (Two leads) φb applies between L1 and .500 (12.70 mm) from the seating plane.

Diameter is uncontrolled in L1 and beyond .500 (12.70 mm) from the seating plane.

4.    Two leads.

5.    Two holes.

6.    Two holes located at true position within diameter .010 (.25 mm).

7.    Leads having a maximum diameter .043 (1.09 mm) measured in gaging plane .054 (1.37 mm) + .001 (.03 mm) -

.000 (.00 mm) below the seating plane shall be located at true position within diameter .014 (.36 mm).

8.    The mounting surface of the header shall be flat to convex within .003 (.08 mm) inside a .930 (23.62 mm)

diameter circle on the center of the header and flat to convex within .006 (.15 mm) overall.

FIGURE 4.   Case outline Y (device types 04, 05, and 06).

24