MIL-M-38510-117 Microcircuits, Linear, Adjustable, Positive, Voltage Regulators, Monolithic SiliconThis specification covers the detail requirements for three and four terminal monolithic silicon, adjustable, positive, voltage regulators. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.4.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60

MIL-M-38510/11?C

TABLE I. Electrical performance characteristics - Continued.

Test	Symbol	Conditions 1/ 2/ -55°C ≤ TA ≤ +125°C see figure 10 and 3.5 unless otherwise specified		Device type	Limits		Unit
					Min	Max
		Input voltage	Load current
Ripple rejection	�VIN / �VOUT	VIN = 6.25 V, 4/ ei = 1 Vrms, at f = 2400 Hz	IL = -500 mA, TA = 25°C, see figure 11	06	65		dB
Output noise voltage	VNO	VIN = 6.25 V, 4/ see figure 12	IL = -100 mA, TA = 25°C	06		120	µVrms
Line transient response	�VOUT / �VIN	VIN = 6.25 V, 5/ �VIN = 3.0 V, see figure 13	IL = -10 mA, TA = 25°C	06		12	mV/V
Load transient response	�VOUT / �IL	VIN = 6.25 V, 5/ see figure 14	IL = -100 mA, �IL = -400 mA TA = 25°C	06		0.30	mV/mA

1/ All tests performed at TA = 125°C may at the manufacturer's option, be performed at TA = 150°C.

Specifications for TA = 125°C shall then apply at TA = 150°C.

2/ Static tests with load currents greater than 5 mA are performed under pulsed conditions defined on figures 9 or

10 as applicable.

3/ Output voltage recovery test shall be performed, with the designated load conditions, immediately after removal of each IOS test forced output voltage condition.

4/ The meter for ei and eo shall have a minimum bandwidth from 10 Hz to 10 kHz and shall measure true rms voltages.

5/ The oscilloscope shall have a bandwidth between 5 and 15 MHz.