TABLE III. Group A inspection for device type 02 - Continued
Terminal conditions 13/
1/ Momentarily apply 2.4 V, then ground prior to taking measurements to set the device in desired state. Maintain ground for measurement.
2/ Apply 4.5 V pulse, then ground prior to taking measurements to set the device in desired state. Maintain ground for measurement.
3/ Output voltages shall be either:
(a) H = 2.4 volts minimum and L = 0.4 volt maximum when using a high speed checker double comparator, or
(b) H � 1.5 volts and L ≤ 1.5 volts when using a high speed checker single comparator.
4/ Only a summary of attributes data is required.
5/ A � 2.0 V, B ≤ 0.8 V. Input voltages shown are the maximum for VIL and the minimum for VIH.
6/ Input pulse must be applied 1 time after R0 pulses.
7/ Input pulse must be applied 2 times after R0 pulses.
8/ Input pulse must be applied 4 times after R0 pulses.
9/ FMAX, minimum limit specified is the frequency of the input pulse. The output frequency shall be one-half of the input frequency.
10/ Connect terminals together during test.
11/ See test figure 6 for terminal load.
12/ Omit specified loads for this test.
13/ Terminal conditions (pins not designated may be H � 2.0 V, or L ≤ 0.8 V, or open).
14/ The limits shown are as follows:
Test |
Min/Max limits (mA) for circuit: |
||||
A |
B |
C |
D |
E |
|
IIL1 |
-0.4/-1.3 |
-0.4/-1.3 |
-0.4/-1.3 |
-0.7/-1.6 |
-0.7/-1.6 |
IIL2 |
-0.7/-3.2 |
-0.7/-3.2 |
-0.7/-3.2 |
-0.7/-3.2 |
-0.7/-3.2 |
IIL3 |
-0.7/-3.2 |
-0.7/-3.2 |
-0.7/-3.2 |
-0.7/-3.2 |
-0.7/-3.2 |
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business