MIL-M-38510/111A
f. Requirements for failure analysis (including required test condition of MIL-STD-883, method 5003), corrective action and reporting of results, if applicable.
g. Requirements for product assurance options.
h. Requirements for special carriers, lead lengths, or lead forming, if applicable. These requirements should not affect the part number. Unless otherwise specified, these requirements will not apply to direct purchase by
or direct shipment to the Government.
i. Requirements for "JAN" marking.
j. Packaging requirements (see 5.1).
6.3 Superseding information. The requirements of MIL-M-38510 have been superseded to take advantage of the available Qualified Manufacturer Listing (QML) system provided by MIL-PRF-38535. Previous references to MIL-M-38510 in this document have been replaced by appropriate references to MIL-PRF-38535. All technical requirements now consist of this specification and MIL-PRF-38535. The MIL-M-38510 specification sheet number and PIN have been retained to avoid adversely impacting existing government logistics systems and contractor's parts lists.
6.4 Qualification. With respect to products requiring qualification, awards will be made only for products which are, at the time of award of contract, qualified for inclusion in Qualified Manufacturers List QML-38535 whether or not such products have actually been so listed by that date. The attention of the contractors is called to these requirements, and manufacturers are urged to arrange to have the products that they propose to offer to the Federal Government tested for qualification in order that they may be eligible to be awarded contracts or purchase orders for the products covered by this specification. Information pertaining to qualification of products may be obtained from DSCC-VQ, 3990 E. Broad Street, Columbus, Ohio 43123-1199.
6.5 Abbreviations, symbols, and definitions. The abbreviations, symbols, and definitions used herein are defined in
MIL-PRF-38535, MIL-HDBK-1331, and as follows:.
+VCC ................................................. Positive supply voltage
-VCC ................................................. Negative supply voltage
+ICC ................................................. Positive supply current
-ICC ................................................. Negative supply current
VL ................................................. Logic supply voltage
IL ................................................. Logic supply current
RDS ................................................. Resistance of an "ON" switch
VD ................................................. Drain voltage VS ................................................. Source voltage ID ................................................. Drain current
IS ................................................. Source current
ID(ON) ................................................. Leakage current from an "ON" driver into the switch
ID(OFF) ................................................. Leakage current into the drain terminal of an "OFF" switch IS(OFF) ................................................. Leakage current into the source terminal of an "OFF" switch tON ................................................. Switching time as defined in figure 5
tOFF ................................................. Switching time as defined in figure 5
VA ................................................. Analog signal voltage
IR ................................................. Reference current
VR ................................................. Reference voltage
VCTE ................................................. Charge transfer error
VCT ................................................. Crosstalk between switches
VISO ................................................. Isolation from source to drain of a closed switch
6.6 Logistic support. Lead materials and finishes (see 3.4) are interchangeable. Unless otherwise specified, microcircuits acquired for Government logistic support will be acquired to device class B (see 1.2.2), lead material and finish A (see 3.4). Longer length leads and lead forming should not affect the part number.
53
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business