MIL-M-38510-140 Microcircuits, Linear, Monolithic And Hybrid Silicon, Microprocessor Compatible, 12 Bit Analog-To-Digital ConvertersThis specification covers the detail requirements for monolithic and hybrid, microprocessor compatible, 12-bit successive approximation analog-to-digital converters buffered outputs. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55

MIL-M-38510/140A

3.4  Lead material and finish.  The lead material and finish shall be in accordance with MIL-PRF-38535 (see 6.6).

3.5  Electrical performance characteristics.  The electrical performance characteristics are as specified in table I, and apply over the full recommended ambient operating temperature range, unless otherwise specified.

The following conditions shall also apply unless otherwise specified:

Unipolar operation                                               VFSR = 10 V VCC = +15.0 V                                                   VEE = -15 V

CS  input = logic "0"                                  Logic "0" = 0.8 V maximum

CE input = logic "1"                                    Logic "1" = 2.0 V minimum

12/ 8  input = V                                                VLOG = +5.0 V

-55°C ≤ TA ≤ +125°C

3.6  Electrical test requirements.  Electrical test requirements for each device class shall be the subgroups specified in table II.  The electrical tests for each subgroup are described in table III.

3.7  Marking.  Marking shall be in accordance with MIL-PRF-38535.

3.7.1  Correctness of indexing and markings.  All devices shall be subjected to the final electrical tests subgroups 1 and 4 specified in table II after part marking to verify that they are correctly indexed and identified by part number. Optionally, an approved electrical test may be devised especially for this requirement.

3.8  Microcircuit group assignment.  The devices covered by this specification shall be in microcircuit group H

and number 57 (see MIL-PRF-38535, appendix A).

4

For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business