MIL-M-38510-110 Microcircuits, Linear, Quad Operational Amplifiers, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, quad operational amplifiers. Two product assurance classes and a choice of case outlines and lead finish are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40

MIL-M-385101110C

TABLE I.  Electrical performance characteristics - Continued.

11  Device types 01 to 04 shall be tested at VCM = 0 V, +15 V, and -15 V with ±VCC = ±20 V; and at VCM = 0 V with

±VCC = ±5 V.  Device types 05 and 06 should be tested at VCM = -13 V with VCC = 2 V and -VCC = -28 V; VCM = +15 V with +VCC = 30 V and -VCC = 0 V; VCM = +1.4 V with VCC = 5 V and -VCC = 0 V;

VCM = -1.1 V at ±VCC = 2.5 V.

21  CMR is determined by measuring input offset voltage as follows:

31  Continuous limits will be considerably lower and apply for -55°C ≤ TA ≤ 25°C.

41  ISO(+) and ISO(-) limits for device type 01 only at TA = -55°C are -75 mA and 75 mA respectively.

51  ICC limits are the total for all four amplifiers at no load, connected as grounded followers.

61  AVS(+) for device types 05 and 06 only.

71  Device types 05 and 06 transient response is specified with the input pulse referenced to 5 V.  For application purposes the device may be operated with the input referenced to ground, however, saturation effects will cause the response time to increase by approximately 50 percent.

13