MIL-M-38510-133 Microcircuits, Linear, 10-Bit Digital-To-Analog Converter, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, 10-bit binary digital-to-analog converters containing deposited thin film resistor networks. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23

MIL-M-38510/1338

NOTES:

1.   Unless otherwise stated, all capacitors are 47 µF tantalum paralleled with 0.1 µF ceramic.

2.   The meter shall be true rms reading with a bandwidth greater than 100 kHz.

3.   A1, A2, and A3 shall have a gain-bandwidth product greater than 5 MHz and input noise

density less than 10 nV/   Hz .

4.   All "A" point ground connections shall return to a single unipoint ground at device pin 1.

5.   With S-1 in position 2, the measured rms noise voltage shall be less than 1.0 mV rms. (NO for all bits off.)

6.   With S-1 in position 1, the measured rms noise voltage shall be:

NO for OUT = √ (NO)2  for all bits on - (NO)2  for all bits off

100

Figure 5.  Test circuit for noise tests.

12

For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business