MIL-M-38510-125 Microcircuits, Linear, Sample And Hold Circuits, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, sample and hold circuits. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.4

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39

MIL-M-38510/1258

NOTES:

1. Last component designations are R13, C9, U2, 04, and K8

2. All resistors are ±1 % film unless otherwise stated.

3. U1 offset error shall be measured with pin 9 grounded and the device under test (0.U.T.) removed.

This error shall be removed in the software calculations.

4. Relay control inputs are not shown.

5. A speed-up circuit is required in series with the logic input for rise times greater than 0.5 µs.

6. The adapter S/H U2 is required for TA = 125°C testing of some parameters.

FIGURE 3. Test circuit for static and dynamic tests.