MIL-HDBK-780D
w/CHANGE 1
5.3.8.1.2 Substitutability. The substitutability should be as shown on figure 5 in 6.1.2.
5.3.8.2 Configuration control of SMD's. The configuration control of SMD's should be as shown on figure 5 in 6.2.
5.3.8.3 Record of users. The record of users should be as shown on figure 5 in 6.3.
5.3.8.4 Comments. The comments should be as shown on figure 5 in 6.4.
5.3.8.5 Abbreviations, symbols, and definitions. The abbreviations, symbols, and definitions should be as shown on figure 5 in 6.5.
5.3.8.6 Sources of supply. The sources of supply paragraph should be as shown on figure 5 in 6.6.
6. NOTES
6.1 Intended use. The issue of SMD's is intended to minimize the proliferation of duplicate drawings for an item of supply. The use of one drawing for an item of supply within DoD is the objective of the SMD program. SMD's are currently applicable to the acquisition of microcircuits only.
6.1.1 Standard microcircuit drawing program (SMDP). The SMDP is related to the Configuration Management and Parts Management Programs. SMDs are recognized in ASME Y14.100 for application by the DoD for microcircuits compliant with MIL-STD-883. Non-standard microcircuits parts approval is obtained through the procedures of MIL- STD-3018 and SD-19.
6.2 Draft construction. Communication with the MPCAG point of contact for the purpose of draft SMD construction
* will usually be through use of computer or word processor. DLA Land and Maritime - VA, should be contacted concerning system capability, and modem and telecommunication compatibility (see
figure 4).
6.3 Certificate of compliance. A Certificate of Compliance (C of C) is a document by which an authorized official of the microcircuit manufacturer certifies that the microcircuit being supplied in accordance with the applicable SMD by the vendor meets the Item Requirements as stated therein. The C of C is delivered by the vendor to the MPCAG with the final SMD.
6.4 Subject term (key word) listing.
Certificate of compliance
Military parts control advisory group Parts Management program Standard microcircuit drawing Qualified manufacturers list
* 6.5 Change notations. The left margins of this handbook are marked with asterisks to indicate modifications generated by this change. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business