MIL-HDBK-780D
w/CHANGE 1
5.3.5.3.4 Block diagram. Although figure 5, 3.2.4 specifies block diagram, this paragraph will be used to designate block, functional, or logic diagram, as appropriate, for the device being documented.
5.3.5.3.5 Truth tables. Truth tables should appear as on figure 5 in 3.2.3.
5.3.5.3.6 Case outline(s). Case outline(s) should appear as on figure 5 in 3.2.1.
5.3.5.3.7 Electrical performance characteristics and postirradiation parameter limits. Electrical performance characteristics should be as shown on figure 5 in 3.3. Valid characterization data supplied by the manufacture will determine the use of ambient or case operation temperature range.
5.3.5.3.8 Electrical test requirements. Electrical test requirements should be as shown on figure 5 in 3.4.
5.3.5.3.9 Marking. Marking should be as shown on figure 5 in 3.5.
5.3.5.3.10 Tables. Tables e.g., table I, electrical performance characteristics, should be as shown on figure 5. If necessary, a device type column may be added between the Conditions and group A subgroups column to accommodate differences in test conditions and limits, when more than one device type is being specified.
Required temperature parameters for each specific part will be typed under the heading Conditions, as shown on figure 5.
5.3.5.3.11 Graphics.
a. Views that are referenced as shown on figure 5 in 3.2, will be located after table 1.
b. All data necessary for terminal connections will be identified in a table format or be drawn as defined in MIL- STD-1835. Refer to sample SMD, figure 6.
c. Whenever two different case outlines are required, an additional page will be added to accommodate the required data with figure 1 continued.
d. All data necessary for additional views will be drawn as defined in MIL-PRF-38535. Refer to sample SMD, figure 6. Use valid characterization data supplied by the manufacturer for the specific device type.
e. Switching times test circuit and waveforms that are required will be drawn similar in format to that shown on the sample SMD, figure 6. Use valid characterization data supplied by the manufacturer for the specific device type.
5.3.5.3.12 Certificate of compliance. The certificate of compliance execution should be as shown on figure 5 in
3.6.
5.3.5.3.13 Certificate of conformance. The certificate of conformance should be as shown on figure 5 in 3.7.
5.3.5.3.14 Notification of change. Notification of change should be as shown on figure 5 in 3.8.
5.3.5.3.15 Verification of change. Verification of change should be as shown on figure 5 in 3.9.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business