MIL-HDBK-780D
w/CHANGE 1
1. SCOPE
1.1 Scope. This handbook provides guidance and information concerning standard microcircuit drawings (SMD's). System applications are subject to the approval of the applicable program office. This handbook is for guidance only and cannot be cited as a requirement.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed below are not necessarily all of the documents referenced herein, but are those needed to understand the information provided by this handbook.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a part of this document to the extent specified herein.
DEPARTMENT OF DEFENSE SPECIFICATIONS
MIL-PRF-38534 - Hybrid Microcircuits, General Specification for
MIL-PRF-38535 - Integrated Circuits (Microcircuits) Manufacturing, General Specification for
DEPARTMENT OF DEFENSE STANDARD
MIL-STD-883 - Test Method Standard Microcircuits
* MIL-STD-1835 - Department of Defense Interface Standard, Electronic Component Case Outlines
* MIL-STD-3018 - Parts Management Standard
DEPARTMENT OF DEFENSE HANDBOOK
MIL-HDBK-103 - List of Standard Microcircuit Drawings (SMD's)
* (Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
* 2.2.2 Other Government documents, drawings, and publications. The following other Government documents, drawings, and publications form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract
DEFENSE STANDARDIZATION PROGRAM OFFICE.
* SD-19 - Parts Management Guide
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this document to the extent specified herein.
* ASME International (ASME)
* ASME Y14.5 - Dimensioning and Tolerancing
ASME Y14.100 - Engineering Drawing Practices
* (Copies of these documents are available online at https://www.asme.org/ or from the ASME International, Three
Park Avenue, New York, NY 10016-5990).
2.4 Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
1
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business