MIL-HDBK-780D
w/CHANGE 1
5.3.5.1.2.1 PIN length. The length of the PIN should comply with ASME Y14.100 and not exceed 32 characters.
5.3.5.1.3 Radiation hardness assurance (RHA) designator. Radiation hardness assurance should be as shown on figure 5 in 1.2.1.
5.3.5.1.4 Device type(s). Device type(s) should be as shown on figure 5 in 1.2.2.
5.3.5.1.5 Device class designator. The device class designator should be as shown on figure 5 in 1.2.3.
5.3.5.1.6 Case outline. The case outline(s) should be as shown on figure 5 in 1.2.4.
5.3.5.1.7 Lead finish. Lead finish should be as shown on figure 5 in 1.2.5.
5.3.5.1.8 Absolute maximum ratings.
a. The absolute maximum rating will be typed in two columns with dashes connecting as shown in the sample
SMD, on figure 6.
b. The absolute maximum ratings will be as defined in the valid characterization data supplied by the manufacturer for the specific part and must include the thermal resistance, as specified in MIL-STD-1835 for the applicable case outline.
c. Foot notes referenced in this paragraph will be located at the bottom of the page.
5.3.5.1.9 Recommended operating conditions.
a. The recommended operating conditions will be typed in two columns with dashes connecting, as shown in the sample SMD, on figure 6.
b. The recommended operating conditions will be as defined in the valid characterization data supplied by the manufacturer for the specific part.
c. Foot notes referenced in paragraph 1.4 will be located at the bottom of the page.
5.3.5.2 SECTION 2, applicable documents. Section 2 should appear as shown on figure 5 and follow the guidelines of 4.2.3 as contained herein.
5.3.5.2.1 Order of precedence. Order of precedence should be as shown on figure 5 in 2.2 and 4.2.3.1.3 as specified herein.
5.3.5.3 Section 3, requirements. Section 3 should appear as shown on figure 5 and the guidelines furnished in
4.2.4. Specific requirement paragraphs should be included in an SMD or on an as required basis.
5.3.5.3.1 Item requirements. Item requirements should be as shown on figure 5 in 3.1.
5.3.5.3.2 Design, construction and physical dimensions. Design, construction and physical dimensions should be as shown on figure 5 in 3.2.
5.3.5.3.3 Terminal connections. Terminal connections should be as shown on figure 5 in 3.2.2.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business