MIL-HDBK-780D
w/CHANGE 1
5.3.6 Section 4, verfication. Section 4 should appear as shown on figure 5 and 4.2.5 as contained herein.
5.3.6.1 Sampling and inspection. Sampling and inspection should be as shown on figure 5 in 4.1.
5.3.6.2 Screening. Screening should be as shown on figure 5 in 4.2. Valid characterization data supplied by the manufacturer will be used for figure 5, 4.2.1a and 4.2.1b.
5.3.6.3 Qualification inspection. Qualification inspection should be as shown on figure 5 in 4.3.
5.3.6.4 Conformance inspection. Conformance inspection should be as shown on figure 5 in 4.4 and the guidance contained in 4.2.5.4 herein.
5.3.6.4.1 Group A inspection. Additional group A inspection requirements should be as shown on figure 5 in 4.4.1. Valid characterization data supplied by the manufacturer will be used for 4.4.1 subparagraphs (see figure 5).
5.3.6.4.2 Group C inspection. Additional group C inspection requirements should be as shown on figure 5 in 4.4.2. Valid characterization data supplied by the manufacturer will be used for 4.4.2 subparagraphs (see figure 5).
5.3.6.4.3 Group D inspection. Additional group D inspection requirements should be as shown on figure 5 in 4.4.3.
5.3.6.4.4 Group E inspection. Additional group E inspection requirements should be as shown on figure 5 in 4.4.4. Valid characterization data supplied by the manufacturer will be used for 4.4.4 subparagraphs.
5.3.6.5 Tables, electrical tests.
a. The table of electrical test requirements will be formatted as shown on figure 5, table II.
b. The identification of subgroups and tests will be defined in the applicable general specification and valid characterization data supplied by the manufacturer.
c. Any footnote referenced in the table will be located a minimum of two line spaces below the bottom line of the table.
d. Notes using the term guaranteed will not be included as a part of the preliminary draft, before submittal to the sources of supply.
5.3.7 Section 5, packaging. Section 5 should appear as shown on figure 5 and the guidance indicated in 4.2.6.1 as specified herein.
5.3.7.1 Packaging requirements. The packaging requirements should be as shown on figure 5 in 5.1.
5.3.8 Section 6, notes. Section 6 should appear as shown on figure 5 and the guidance in 4.2.7 as specified herein.
5.3.8.1 Intended use. The intended use should be as shown on figure 5 in 6.1 and the guidance in 4.2.7.2 as specified herein.
5.3.8.1.1 Replaceability. The replaceability should be as shown on figure 5 in 6.1.1.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business