MIL-M-38510-61 Microcircuits, Digital, Ecl, Flip-Flops, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, ECL, logic gating microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48

MIL-M-38510/61C

GENERATOR CHARACTERISTICS            

    zOUT = 50ν

    tP (data) = 150 ns

    tP (clocka) = 40 ns

    PRR = 1 MHz

    Device type 01

        tTHL = 2.0 ns (20%-80%)

        tTLH = 2.0 ns (20%-80%)

    Device type 02

        tTHL = 1.5 ns (20%-80%)

        tTLH = 1.5 ns (20%-80%)

RL    

2

= 50ν ±5%                             

SCOPE INPUT = 50ν to GND    CL (test jig) ≤ 5 pF                         

                                                         

NOTES:

1.   Perform test in accordance with test table; each output is tested separately.

2.   All input and output cables are equal lengths of 50 ohm coaxial cables.  Wire length should be ≤ .250 

      (6.35 mm) from tp in to input pin and tp out to output pin.

3.   Outputs not under test connected to a 100 ohm resistor to ground.

4.   Note that observed pulse amplitude is attenuated by one half.

FIGURE 5.  Synchronous switching test circuit for device types 01 and 02.

15

Source:  https://assist.dla.mil  --  Downloaded: 

Check  the  source  to  verify  that  this  is  the  current  version  before  use.

For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business