MIL-M-38510-61 Microcircuits, Digital, Ecl, Flip-Flops, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, ECL, logic gating microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48

MIL-M-38510/61C

GENERATOR CHARACTERISTICS            

    zOUT = 50ν

    tP (P/S & CLR) = 40 ns

    PRR = 1 MHz

    Device type 01

        tTHL = 2.0 ns (20%-80%)

        tTLH = 2.0 ns (20%-80%)

    Device type 02

        tTHL = 1.5 ns (20%-80%)

        tTLH = 1.5 ns (20%-80%)

RL    

2

= 50ν ±5%                             

SCOPE INPUT = 50ν to GND    CL (test jig) ≤ 5 pF                         

                                                         

NOTES:

1.   Perform test in accordance with test table; each output is tested separately.

2.   All input and output cables are equal lengths of 50 ohm coaxial cables.  Wire length should be ≤ .250 

      (6.35 mm) from tp in to input pin and tp out to output pin.

3.   Outputs not under test connected to a 100 ohm resistor to ground.

4.   Note that observed pulse amplitude is attenuated by one half.

FIGURE 4.  Preset and clear switching test circuit for device types 01 and 02.

14

Source:  https://assist.dla.mil  --  Downloaded: 

Check  the  source  to  verify  that  this  is  the  current  version  before  use.

For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business