MIL-M-38510-12 Microcircuits, Digital, Bipolar, Ttl, Monostable Multivibrators, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, bipolar, TTL, monostable multivibrators microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55

TABLE III.  Group A inspection for device type 03 - Continued.

Terminal conditions (pins not designated may be high � 2.4 V, low s 0.4 V, or open)

1/    RXCX connected to VCC through a 5 kn resistor.

2/    CX connected to GND or 0.8 V.

3/    For schematic circuits A, B, and C, the minimum and maximum limits shall be -1.4 mA  and -0.2 mA, respectively.  For schematic circuit D, the minimum and maximum limits shall be -0.7 mA and -1.4 mA, respectively.

4/    In transition from low level to high level.

5/    In transition from high level to low level.

6/    One low logic level pulse.  At manufacturer's option, this may be verified in subgroups 9, 10, 11.

7/    Output voltages for subgroups 7 and 8:  H > 1.5 V, L > 1.5 V.

8/    One high logic level pulse.  At manufacturer's option, this may be verified in subgroups 9, 10, 11.

9/    CX connected to RXCX through a 1,000 pF capacitor.

10/  RXCX connected to VCC through a 10 kn resistor.

11/  Device must be triggered before tPLH3 and tPHL3 can be measured (see figure 7).

12/  CX connected to RXCX through a 15 pF capacitor which includes stray, probe, and jig capacitance.

13/  This test shall be performed for bench setup only.

14/  This test shall be performed for automatic test equipment only.