MIL-M-38510/190D
6.3 Qualification. With respect to products requiring qualification, awards will be made only for products which are, at the time of award of contract, qualified for inclusion in Qualified Manufacturers List QML-38535 whether or not such products have actually been so listed by that date. The attention of the contractors is called to these requirements, and manufacturers are urged to arrange to have the products that they propose to offer to the Federal Government tested for qualification in order that they may be eligible to be awarded contracts or purchase orders for the products covered by this specification. Information pertaining to qualification of products may be obtained from DSCC-VQ, 3990 E. Broad Street, Columbus, Ohio 43123-1199.
6.4 Superseding information. The requirements of MIL-M-38510 have been superseded to take advantage of the
available Qualified Manufacturer Listing (QML) system provided by MIL-PRF-38535. Previous references to MIL-M-38510 in this document have been replaced by appropriate references to MIL-PRF-38535. All technical requirements now consist of this
specification and MIL-PRF-38535. The MIL-M-38510 specification sheet number and PIN have been retained to avoid adversely impacting existing government logistics systems and contractor's parts lists.
6.5 Abbreviations, symbols, and definitions. The abbreviations, symbols, and definitions used herein are defined in
MIL-PRF-38535 and MIL-HDBK-1331 and as follows:
VIC ................................................ Input clamp voltage.
IIL ................................................. Low level (address) input current.
IIH ................................................. High level (address) input current.
IS(OFF) ................................................. Leakage current into the source terminal of an "OFF" switch.
ID(OFF) ................................................. Leakage current into the drain terminal of an "OFF" switch.
ID(ON) ................................................. Leakage current from an "ON" driver into the switch.
I(+) ................................................. Positive supply current.
I(-) ................................................. Negative supply current. I(SBY) ................................................. Standby supply current.
RON ................................................. Resistance of an "ON" switch. CA ................................................. Address capacitance.
COS ................................................. Output switch capacitance.
CIS ................................................. Input switch capacitance.
CIOS ................................................. Input to output (feedthrough) capacitance.
tPLH ................................................. Propagation delay time: low to high level.
tPHL ................................................. Propagation delay time: high to low level.
GND ................................................. Electrical ground.
VREF ................................................. Reference voltage.
A ................................................. Address input to switch.
EN ................................................. Enable.
O/I ................................................. Output/Input. I/O ................................................. Input/Output.
6.6 Logistic support. Lead materials and finishes (see 3.4) are interchangeable. Unless otherwise specified, microcircuits acquired for Government logistic support will be acquired to device class B (see 1.2.2), lead material and finish A (see 3.4). Longer length leads and lead forming should not affect the part number.
83
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business