MIL-M-38510-119 Microcircuits, Linear, Low Power, Low Noise, Bi-Fet Operational Amplifiers, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, BI-FET operational amplifiers. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25

MIL-M-38510/1198

NOTES:

1.    Resistors are ±0.1 percent tolerance and all capacitors are ±10 percent unless otherwise specified.

2.        Precautions shall be taken to prevent damage to the device under test (OUT) during insertion into socket and in applying power.

3.    Selection circuitry for dual and quad devices is not shown.

4.        Settling time ts, measured on pin 5, is the interval during which the summing mode is not nulled to within ±5 mV.

5.    For device types 01, 02, and 03, R1 = R2 = 10 kn.

6.    For device types 04, 05, and 06, R1 = R2 = 2 kn.

7.    1N5711 Schottky diodes.  Add as needed to limit oscilloscope overdrive caused by the instantaneous

transition of VIN.

FIGURE 5.  Test circuit for settling time.

14

For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business