MlL-M-385101119B
TABLE l. Electrical performance characteristics - Continued.
11 For devices marked with the "Q" certification mark, the parameters listed herein may be guaranteed if not tested to the limits specified in accordance with the manufacturer's QM plan.
21 llO is calculated as the difference between +llB and -llB.
31 Bias current is actually junction leakage current which double (approximately) for each 10°C increase in junction
temperature (TJ). To minimize thermal transient due to warm-up, measurements for bias current must be made within 25 ms after power is first applied to the device for test.
41 Bias current is sensitive to power supply voltage, common mode voltage, and temperature as shown by the
following typical curves:
51 CMR is calculated from VlO measurements at VCM = +11 V and -11 V.
61 Offset adjustment pins do not exist for 8-pin dual and 14-pin quad packages.
71 Continuous limits shall be considerable lower. Protection for shorts to either supply exists providing that
TJ(max) ≤ 175°C.
81 Because of thermal feedback effects from output to input, open loop gain is not guaranteed to be linear or
positive over the operating range. These requirements, if needed, should be specified by the user in additional acquisition documents.
91 Channel separation is applicable only for the dual and quad devices.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business