MIL-M-38510-314 Microcircuits, Digital, Low-Power Schottky, Ttl, Monostable Multivibrators, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, low-power Schottky TTL, monostable multivibrator microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32

TABLE III.  Group A inspection for device type 03 - Continued.

Terminal conditions (pins not designated may be high � 2.0 V, low s 0.7 V, or open).

NOTES:

A.   VIN  = 3.0 V minimum. B.   VIN  = 0.0 V or GND.

C.  For circuit D, IIL1 limits are 120 to 360 mA.

D.  Test numbers 29 through 45 shall be run in sequence. E.  Output voltages shall be either:

H > 1.5 V;  L < 1.5 V

F.   Cext connected to Rext/Cext through a 1,000 pF ±10% capacitor. G.  Rext/Cext connected to VCC  through a 5 kn ±10% resistor.

I.    Note K may apply during subgroups 1, 2, and 3 testing if desired.

J.       Apply input pulse

┌────┐ -  -  - 2.5 V min/5.5 V max.

──┘           └──  0 V

K.   Rext/Cext connected to VCC  through a 5 kn to 180 kn resistor, and Cext connected to Rext/Cext through a s 1,000 µF capacitor. M.  Cext connected to Rext/Cext through A � 45 pF capacitor, Rext/Cext connected to VCC  through a 10 kn ±10% resistor.

N.  Rext/Cext connected to VCC  through a 10 kn ±10% resistor.