MIL-M-38510-314 Microcircuits, Digital, Low-Power Schottky, Ttl, Monostable Multivibrators, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, low-power Schottky TTL, monostable multivibrator microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32

TABLE III.  Group A inspection for device type 01.

Terminal conditions (pins not designated may be high � 2.0 V, low s 0.7 V, or open).  1/

NOTES:

A.   VIN  = 3.0 V minimum. B.   VIN  = 0.0 V or GND.

C.       Apply input pulse

┌────┐ -  -  - 2.5 V min/5.5 V max.

──┘           └──    0 V

D.  Test numbers 39 through 55 shall be run in sequence. E.  Output voltages shall be either:

H > 1.5 V;  L < 1.5 V

F.   Rext = 5 kn minimum to 180 kn maximum, connected to VCC; Cext s 1,000 µF, connected to Rext terminal. G.  Rext = 5 kn ±10%, connected to VCC.

I.    Rext = 10 kn ±10%, connect to VCC; Cext s 1,000 µF ±10%, connected to Rext terminal.

J.   During subgroups 9, 10, 11 testing, Rext and Cext may remain applied on the side of the device not under test if desired. K.   For circuit D, IIL1  limits are 120 mA to 360 mA.

L.   Rext = 10 kn ±10%, connect to VCC; Cext � 45 pF connected to Rext terminal.