MIL-M-38510-21 Microcircuits, Digital, Bipolar, Ttl, Low Power, Flip-Flops, Monolithic SiliconThis specification covers the detail requirements for monolithic, silicon, TTL, low power, bistable logic microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.4.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44

TABLE III.  Group A inspection for device type 04.- Continued. 1/

NOTE:   A = normal clock pulse, B = momentary GND, then 4.5 V, E = momentary GND, then open.

J = input pulse, tp  � 100 ns, VOL  = 0 V, VOH = 4.5 V.

1/    Terminal conditions (pins not designated may be H � 2.0 V, or L ≤ 0.8 V, or open).

2/    Tests shall be performed in sequence.

3/    Output voltages shall be either:  (a)  H = 2.4 V, minimum and L = 0.4 V, maximum when using a high speed checker double comparator; or

(b)   H � 1.5 V and L ≤ 1.5 V when using a high speed checker single comparator.

4/    Input voltages shown are:  A = 2.4 V minimum and B = 0.4 V maximum.

5/    fMAX, minimum limit specified is the frequency of the input pulse.  The output frequency shall be one-half of the input frequency.

*      These tests are performed at device manufacturer's option.