MIL-M-38510/126C
TABLE III. Group A inspection - Continued.
NOTES:
1/ This test applies to device type 02 only.
2/ 5 V, 50 μs pulse, toggles the "on state" between transistors A and B.
3/ Vary VCM from 1.5 V to 5.2 V and measure change on pin 9, VN = 2.5 V.
Equation for CMR test is : CMR = 20 Log I VCM (101) / ( EX - VCM )I Test 18, EX = E16
Test 40, EX = E35
Test 61, EX = E53
4/ Load resistance on outputs A and B 1 kν.
5/ 0.8 V to 2.8 V transition on VSYNC must cause a transition in VOSC.
2.8 V to 0.8 V transition on VSYNC must not cause a transition in VOSC.
6/ Apply 0.5 V to the shutdown pin, output should be on. ( Device type 02 either output > 2.5 V ) ( Device type 04 either output ε 2.5 V ).
7/ Apply 1.6 V to the shutdown pin, output should be off. ( Device type 02 both outputs ε 2.5 V) ( Device type 04 both outputs > 2.5 V).
8/ Equation for PSRR is as follows with VN = 5.1 V: PSRR = 20 Log I VIN (101) / ( EX - EY ) I
Test 81, ( EX - EY ) = ( E61 - E62 )
Test 96, ( EX - EY ) = ( E67 - E68 ) Test 112, ( EX - EY ) = ( E73 - E74 )
9/ Increase VIN = from 5 V to the point where outputs are on: ( Device type 02 on state = either output > 2.5 V ), ( device type 04 on state = either output ε 2.5 V ).
10/ Device type 02, tSD = toutput( low ) - tpin 10(high).
Device type 04, tSD = toutput( high ) - tpin 10(high).
11/ Apply a 3.6 V, 50 μs pulse to CT to switch output transistor (which is on).
51
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business