MIL-M-38510-126 Microcircuits, Linear, Regulating, Pulse Width Modulator, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, pulse width modulator microcircuits. Two product assurance classes and a choice of case outlines and lead finishes are provided and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56

MIL-M-38510/126C

NOTES:

1. GBW is measured by increasing signal frequency (starting at 100 kHz) until eO = 20 mV(P-P).

The frequency at which this occurs is GBW.

2. (CL) capacitance load = 20 pF, -10%, on eO including scope probe and jig capacitance.

3. Alternative method: Set signal frequency (ei) to the GBW minimum limit if eO 20 mV(P-P) then

GBW is the minimum limit.

FIGURE 5. Unity gain bandwidth test circuit.