INCH-POUND
MIL-M-38510/7538
26 November 2003
SUPERSEDING MIL-M-38510/753A
27 May 1994
MILITARY SPECIFICATION
MICROCIRCUITS, DIGITAL, ADVANCED CMOS, FLIP-FLOPS, MONOLITHIC SILICON, POSITIVE LOGIC
Reactivated after 26 Nov. 2003 and may be used for either new or existing design acquisitions.
This specification is approved for use by all Departments and Agencies of the Department of Defense.
The requirements for acquiring the product herein shall consist of this specification sheet and MIL-PRF 38535
1. SCOPE
1.1 Scope. This specification covers the detail requirements for monolithic silicon, advanced CMOS, logic microcircuits. Two product assurance classes and a choice of case outlines, lead finishes, and radiation hardness assurance (RHA) are provided and are reflected in the complete Part or Identifying Number (PIN). For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535 (see 6.3).
1.2 Part or identifying number (PIN). The PIN should be in accordance with MIL-PRF-38535 and as specified herein.
1.2.1 Device types. The device types should be as follows: Device type Circuit
01 1/
02 Dual D-type positive-edge triggered flip-flops with clear and set
03 1/
04 Dual JK positive-edge triggered flip-flops with clear and set
05 Dual JK negative-edge triggered flip-flops with clear and set
06 1/
07 Hex D-type flip-flops with master reset
08 Quad D-type flip-flops with reset
1.2.2 Device class. The device class should be the product assurance level as defined in MIL-PRF-38535.
1.2.3 Case outlines. The case outlines should be as designated in MIL-STD-1835 and as follows:
Outline letter Descriptive designator Terminals Package style
C |
GDIP1-T14 or CDIP2-T14 |
14 |
Dual-in-line |
D |
GDFP1-F14 or CDFP2-F14 |
14 |
Flat pack |
E |
GDIP1-T16 or CDIP2-T16 |
16 |
Dual-in-line |
F |
GDFP2-F16 or CDFP3-F16 |
16 |
Flat pack |
Y |
GDFP1-G14 |
14 |
Flat pack with gull wing |
z |
GDFP1-G16 |
16 |
Flat pack with gull wing |
2 |
CQCC1-N20 |
20 |
Square leadless-chip-carrier |
1/ Device types 01, 03, and 06 were intended to be added in the future, see 6.7.
Comments, suggestions, or questions on this document should be addressed to: Commander, Defense Supply Center Columbus, ATTN: DSCC-VAC, 3990 East 8road St., Columbus, OH 43216-5000, or email to cmos@dscc.dla.mil. Since contact information can change, you may want to verify the currency of this address information using the ASSIST Online database at www.dodssp.daps.mil.
AMSC N/A FSC 5962
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business