function generators. Two product assurance classes and a choice of case outlines and lead finishes are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34

TABLE III. Group A inspection for device type 01 - Continued.

Terminal conditions (pins not designated may be high � 2.0 V; low s 0.7 V; or open).

1/ Tests shall be performed in sequence.

2/ Input voltages shown are: A = 2.0 volts minimum and B = 0.7 volts maximum.

3/ Output voltages shall be either: (a) H = 2.5 V, minimum and L = 0.4 V, maximum when using a high speed checker double comparator; or

(b) H > 1.5 V and L < 1.5 V when using a high speed checker single comparator.

4/ All functional tests (82 thru 120) require a 1 kn pull up resistor between pin 14 and VCC.

5/ IIL limits (mA) min/max values for circuits shown: