MIL-M-38510-113 Microcircuits, Linear, 8 Bit, Digital-To-Analog Converters, Monolithic SiliconThis specification covers the detail requirements for monolithic silicon, 8 bit, digital-to-analog converters. Two product assurance classes and a choice of case outlines and lead finishes are provided for each type and are reflected in the complete part number. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535, see 6.4.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31

MIL-M-38510/113C

NOTES:

1. For turn-ON, VL = 2.7 V; for turn-OFF, VL = 0.7 V.

2. Minimize capacitance at this node, by using short runs and adequate spacing between runs.

3. Diodes must be Schottky type (MBD 501 or equivalent).

4. Bandwidth of oscilloscope used for waveform measurement should be 50 MHz minimum;

saturation of preamp must be avoided.

FIGURE 3. Test circuit for propagation delay and settling time, device type 01 and 02.