MIL-M-38510-750 Microcircuits, Digital, Advanced CMOS, Nand Gates, Monolithic Silicon, Positive LogicThis specification covers the detail requirements for monolithic silicon, advanced CMOS, logic microcircuits. Two product assurance classes and a choice of case outlines, lead finishes, and radiation hardness assurance RHA are provided and are reflected in the complete Part or Identifying Number PIN. For this product, the requirements of MIL-M-38510 have been superseded by MIL-PRF-38535 see 6.3.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21

MIL-M-38510/7508

4.5  Methods of inspection.  Methods of inspection shall be specified and as follows:

4.5.1  Voltage and current.  Unless otherwise specified, all voltages given are referenced to the microcircuit GND terminal. Currents given are conventional current and positive when flowing into the referenced terminal.

4.5.2  8urn-in and life test cool down procedures.  When the burn-in and life tests are completed and prior to removal of bias voltages, the devices under test (DUT) shall be cooled to within 10°C of their power stable condition at room temperature; then, electrical parameter end-point measurements shall be performed.

4.5.3  Quiescent supply current.  When performing quiescent supply current measurements (ICC), the meter shall be placed so that all currents flow through the meter.

4.6  Data reporting.  When specified in the purchase order or contract, a copy of the following data, as applicable, shall be supplied.

a.  Attributes data for all screening tests (see 4.2) and variables data for all static burn-in, dynamic burn-in, RHA tests and steady-state life tests (see 3.6).

b.  A copy of each radiograph.

c.   The technology conformance inspection (TCI) data (see 4.4).

d.  Parameter distribution data on parameters evaluated during burn-in (see 3.6). e.  Final electrical parameters data (see 4.2e).

f.   RHA delta limits.

5.  PACKAGING

5.1  Packaging.  For acquisition purposes, the packaging requirements shall be as specified in the contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-house contractor personnel, these personnel need to contact the responsible packaging activity to ascertain packaging requirements.  Packaging requirements are maintained by the Inventory Control Point's packaging activity within the Military Service or Defense Agency, or within the military service's system commands.  Packaging data retrieval is available from the managing Military Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible packaging activity.

6.  NOTES

(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)

6.1  Intended use.  Microcircuits conforming to this specification are intended for original equipment design application and logistic support of existing equipment.

19